Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.

...

Excerpt

The heated bed on the printers is suspended using 4 screws, each compressing a spring. To get the first layer to stick to the build plate properly, the vertical gap between the build plate and the nozzle needs to be correct over the whole build plate.

To adjust the height of the build plate, the springs can be compressed by turning the knobs under each corner of the build plate. Instructions below.

If you don't fee

Kontrollfunktionerna i OctoprrintOctoprint controls

Instructions

...